About this 3D model

This is a chamber heater for P1S X1C. I have added an upward draft baffle in the source model to correct the problem of hot air blowing downwards, which causes heat accumulation and hot deformation of the injection molding parts at the bottom of the printer. Here is the BOM and link for the heater part: PTC heater: https://m.tb.cn/h.5IRTu9AllKbsjJr "200W24V conductive type with bracket ceramic PTC constant temperature air heater heating element corrugated bar rapid heating 92*31" Fan: https://m.tb.cn/h.5IRhupyFyR8WN4h CZ0001 "5015 purifier turbine blower 5cm humidifier centrifugal fan 5V12V24V 3D printer" Please use materials that can withstand ABS and higher temperatures (PC-CF is used here). Please use 17AWG or higher gauge power cables; the cables and temperature control probes can be passed through the holes in the bottom plate for non-destructive installation (tested on P1S printer). It is recommended to use a temperature controller to control the temperature below 65°.