About this 3D model

I have also designed a version of my filament clamp where you can insert a small label with the material on it. I designed it in two parts which are then plugged together. The parts can be printed without support and only 1 filament change is necessary for the plates The parts are best printed in PETG or PETG HF Note: both parts, i.e. clamp and label, should be printed with the same material (otherwise the tolerances for mounting may not match due to different shrinkage behavior). “NotAllowedToBeginWithUser_” has also designed a holder that is attached to the AMS lid and into which the clamps of the filaments in the AMS are then inserted: https://makerworld.com/en/models/1132351