About this 3D model

The original factory LED lights on the P1P/P1S are too dim. To improve the brightness, but without damaging the original lamp condition, I've designed this bracket. It utilizes an 8MM LED white light strip, secured with a slot to prevent it from detaching due to excessive heat. Using GH1.25 terminals, the LED strip is cut to 28mm (I used a 28mm strip with 17 LEDs) and simply soldered. Print the bracket, install the LED strip into the slot, unplug the original LED lamp connector, and connect the soldered GH1.25 terminals. Secure it with an M3X10 screw inside the chassis (position shown in the image). This method is simple, convenient, and non-destructive, allowing continued use of the printer's light control. Please do not consider adding too many LEDs. The official documentation states that this connector can only handle 0.3A, so only one LED strip was installed. This will prevent any damage to the screen board.