About this 3D model

This is rev. 2 of the A1 Top Mount accessories. A version for the A1 Mini can be found at A1 Mini Top Mount Accessories by Jeff Smith - MakerWorld Boost Me If you like this model and find it useful/enjoyable, please consider giving me a boost! Significant changes : There are three receivers, horizontal, 45 degrees, and vertical. They can accept any of the various inserts. The loop connection on the front of the receivers is common, they can optionally use the separate loop for cable management etc. The loops have changed to better capture the cables/PTFE tubes. Print with PLA and they will flex enough to allow you to put the cables/tubes in the loop and go back into shape. All of the inserts now have holes in the end to screw them in. Depending on how you print them, they are either snug (which I like) or they will float a little, the screws are an option to anchor them. The length of the insert has changed, they are longer and can be cut in your slicer if you want them shorter. Note, that the screw holes only go up so far, so you might have to drill out the hole if you make them very short. Hardware: I use M3 screws (hex head) but any will work for the hinges, such as connecting the clamp to the receiver. You can use M3 screws for the other attach points (such as insert into reciever) but you may want to use M3 heatsets. I am not a fan of heatsets unless I have too, so I use #6 x 1" panhead sheet metal screws and the connections are tight.