About this 3D model

This is the revised version of my previous filament clip for Sunlu spools . The optimized design with only two walls allows each layer to be printed in a single pass without any interruption, allowing you to obtain four clip in a few minutes and without defects. It only take less than 93 seconds per clip, and if you want to save another 10 seconds remove the brim (make ensure you have excellent adhesion on your build plate). The extremely flat profile allows the clip to be used even with vacuum bags without the risk of damaging them. The rear tooth ensures the stability of the clip in the spool, the elongated edge allows simple removal and the slot holds the filament securely while allowing it to be removed without damaging it.