About this 3D model

LED Remote Stand _______________________________________________ About: This stand makes your desktop a little more organized by standing up the LED controller. Normally my LED controller was always scattered around on my desk, so I made this. This Might Not Fit The Remote You Have. ____________________________________________ Steps To Print: Simply Print the 3mf in any color and 1 hour later it should be done! ____________________________________________ Dimensions + Print Time + Filament Used: 90mm tall (3.5 inch) 85mm wide (3.25 inch) <1 hour print time! 12g of filament used ____________________________________________ Settings: Layer height: . 28mm Walls: 2 Top shell layers: 4 Bottom shell layers: 3 Infill: 15% _____________________________________________ Extra: This May Not Fit Your Remote More Cool Prints: mwiller | Published - MakerWorld