About this 3D model

In order to achieve the high gloss glass like finish I printed the top section face down against a WhamBam PEX built plate. (Link below) For optimal fidgeting performance the bottom closure plate should be printed against a textured build plate. Each side has (6) 8x3mm neodymium magnets pressed into the holes, I use an arbor press for easy assembly. Remember to reverse the magnet polarity between the two sides. I highly recommend using the Attached m3f file, I slowed down the outer wall and top surface speeds a little bit, which results in a much nicer and much shinier surface finish. The magnets I used were purchased from Amazon, using the link below…. https://linktr.ee/mzmdigitaldesign Arbor presses can also be purchased on Amazon if you are planning on making more than a few of these. These were printed on a stockBambu Labs X1C and P1S Standard 0.4mm nozzle Fine Resolution 0.12mm layer height Infill: 60 As always please let me know if you have any questions! Thank you! Mike