About this 3D model

This LED strip light model and its mounting bracket can be directly slotted into the front crossbar of the P1S, directly illuminating the entire chamber. The original [Bambu Lab] strip light is located on the side, and its position is also relatively low. Coupled with the black glass enclosure of the P1S, it is difficult to see the situation inside, so supplementary lighting is needed. This LED strip light model requires a 5mm wide strip light, with a 5v input power supply. It is typically purchased in 1-meter or 2-meter lengths, and then cut according to the model, with an approximate length of 77mm. I chose a density of 60 LEDs, which provides the right brightness for me. I don't prefer excessively bright lights, as excessive brightness may affect the camera exposure. Those who prefer brighter lights can choose 120 LEDs or lengthen the strip light model. I also made a power supply hub, mainly to link it with the original strip light so that it can turn on and off with the original strip light. For securing the wire and hub, a small amount of tape is sufficient, ensuring that the wires do not come loose and do not obstruct the path of the tool head. Installation method 1: Install one strip light on the front crossbar, which provides sufficient brightness. Installation method 2: Install two strip lights on the front crossbar for even brighter illumination. Installation method 3: Install one strip light on the front crossbar and another on the left side.