About this 3D model

UPDATE 18 NOV 2024 Remix of yet another AMS Riser that definitely fits Bambulab P1S and P1P - but not tested by myself on X1. The oldest file set is for V2 AMS that fits my Bambu P1S that got shipped December 2023. First generation AMS units have a different spacing in the housing and might not slot in! A NEW UPDATED FILE SET ADDRESSING USER FEEDBACK HAS BEEN UPLOADED FOR V3 AMS CUSTOMERS. WARNING: The new files are not tested by myself since I don't have a V3 AMS housing. Only print one half and test before printing the whole set. I am hoping for user feedback. Changelog compared to the file that this is based on: - Added cable hole inside SD card slot to route LED USB cable or power cable. - Increased dimensions by 2mm in length and 1mm in width. Less play when mounted and glass panel drops in WAY EASIER. - Added puzzle style connection at the back. - Added vertical puzzle style connection for the front and side dash. - Aligned the front dash seperation line so that it is exactly centered (WHY NOT in the original?? OCD triggered). - Cleaned up several design errors, TPU glass gasket now symmetrical. - Bambu Logo and Colored Ring now separate files for easy printing and low waste - simply glue them in. - Added cutout for the mysterious hole of the P1 printer on the top right dash so that the riser is sitting flush. This design does not need any support for the LED section at all. Only the single overhang all around the piece is going to be supported and prints nicely due to the changed, vertically oriented interlocking mechanism. The LED have a nice 45 degree angle and illuminate the print room perfectly. You can add a cable wherever you desire. I recommend 5V neon style LED strips with a width of 8mm. 10-12mm will fit without a problem, too. Best practise is to cut the LED strip at every corner and solder a cable instead of bending the LED strip. Personally, I soldered the LED to the original LED connector. It workes for me and enables me to switch the light over the app and BambuStudio but I AM NOT RESPONSIBLE IF IT DOESNT WORK FOR YOU AND YOU BREAK YOUR PRINTER OR OVERDRAW CURRENT ON THAT PORT. I recommend using the additional, free USB connection. The files are preset for PETG material and will result amazing quality as seen on the pictures. The TPU parts slot in nicely and also the glass fits easily without being too tight. Have fun with this hassle free, beautiful and simplistic AMS riser.