About this 3D model

YOU CANNOT SELL THIS WORK In order to sell this work you must purchase a commercial license from the makers of Hueforge. I just have a public license so I am able to share the STL file I made for free! Here is the link to the creators program to purchase! https://shop.thehueforge.com/collections/hueforge --------------------------------------------------------------------------- Bambu P1S - printed using an 0.4mm nozzle and 0.04 layer height, but you will get better results using an 0.2mm nozzle. Slow the speed down by about 25% speed total (even slower than Bambus silent mode) Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm Filaments Used: PLA Elegoo Black - Rapid PLA+ Transmission Distance: 1.5 PLA Inland Purple - PLA+ Transmission Distance: 2.5 PLA Inland Egyptian Blue Transmission Distance: 3.5 PLA Elegoo White - Rapid PLA+ Transmission Distance: 9.5 PLA+ Sunlu Red Transmission Distance: 6 PLA Elegoo Pink - PLA+ Transmission Distance: 7.2 PLA Elegoo Orange Transmission Distance: 12 PLA Elegoo Beige Transmission Distance: 8.8 PLA PolyLite Yellow Transmission Distance: 11 Swap Instructions: Start with Black - Rapid PLA+ At layer #3 (0.24mm) swap to Purple - PLA+ At layer #7 (0.4mm) swap to Egyptian Blue At layer #12 (0.6mm) swap to White - Rapid PLA+ At layer #13 (0.64mm) swap to Red At layer #24 (1.08mm) swap to Pink - PLA+ At layer #28 (1.24mm) swap to Orange At layer #32 (1.4mm) swap to Beige At layer #44 (1.88mm) swap to Yellow for the rest. ---------------------------------------------------------------------------