About this 3D model

Hello everyone, here is my design to allow you to create panels resembling Nanoleaf at a much lower cost You will find the F360 and .step files to remove the marking on the ESP casing if you wish What you will need: -ESP8266 with its power cable -WS2812B LED strip (9 LEDs per panel - use 30LED/m) (https://urlz.fr/idfJ) -3-pin connector (https://urlz.fr/idfF) -DC JACK power connector -100g of PLA filament (for one panel + the ESP module) (one panel = 62g) -A soldering iron Here are the steps for constructing the panels Step 1: Print the two calibration modules and check if they assemble correctly Step 2: Print the different elements according to the desired number of panels Step 3: Fix and solder the LEDs into the panels, as well as the power connections Step 4: Connect the panels together following the wiring diagram Step 5: For attaching the panels, you have the option of using double-sided tape or screwing them in using the holes inside the panels Step 6: For programming the ESP8266, you will need the ESP flasher software and WLED, found in the video description